The BCS and Enercon
field controllers have two stainless steel options:
SSE
The controllers can be housed in an optional 304 grade stainless steel
case.
This case is identical to the standard powder coated case and measures
8.4 X 7.5 X 5.0 inches (21.3 X 19.0 X 12.7 cm). Add SSE to model number
to specify this option. Option cost: $200.00 list.
SSPED
Stainless Steel Pedestal Specifications
16 gauge 304 stainless
steel case and mounting plate with six stainless steel mounting bolts.
Suitable for housing models BCS 5/10 and ECN 4/8/12/18/24.
Dimensions: 35.5
inches high (90.2 cm)
7.5 inches wide (19cm)
5.25 inches deep (13.3 cm)
Weight: 19.0 lb
(8.6 kg) (Pedestal only, no controller)
Option cost: $595.00 list.
Mounting Instructions:
| Step 1: |
Dig
a 3’ x 2’ x 1’ deep hole at the end of the wiring
trench. Place a 11/2 inch diameter schedule 40 sweep L pipe centered
in the hole with about a 2 foot extension laying in the trench.
Make sure pipe end is vertical and extends about 4 inches above
ground level. Cover 3’ x 2’ area with dirt up to about
5 inches below ground level, leaving the pipe extension open in
the trench. Use two 11/2 inch sweeps if needed to accomodate wires.
|
|
|
| Step 2: |
Place rectangular
form inside the 3’ x 2’ x 5 inch deep area and pour
the concrete pad around pipe. After slab is leveled, slide pedestal
mounting bracket with its assembled six bolts extending head down
over the pipe(s). Use level if necessary to insure plate is horizontal.
Allow concrete to set and remove form.
|
| |
|
| Step 3: |
Clean mounting
plate of any dirt or concrete. Remove the six nuts from the plate
and slide pedestal over the plate and bolts. Re-install the nuts
inside the pedestal and tighten snug with pliers or wrench. Slide
field wiring through pipe. Allow about 3ft of slack and connect
to controller output terminals. After wiring is completed and tested,
cover trench with dirt.
|
| |
|
Click here to download the mounting instructions in gif
format or a pdf.
